Hi Jesper.
| "Mike Thomas" writes:
|
| > I was intrigued by this and used the NetInstaller native version of
| > XEmacs with results similar to yours except that I only have
| > "format.tex" and "mylatex.ltx" in my tmp directory and there is no ^M
| > although the cursor is on the line below the (C1) prompt.
|
| What happens when you enter an expression at the prompt? Nothing or an
| error message?
The cursor moves to the line below the expression, but nothing else:
(C1)
1+2;
<CURSOR APPEARS ON THIS LINE>
Note also that the cursor starts at the line below the (C1) prompt rather
than on the same line as would happen when a normal Maxima session starts.
| > Also, when I load "imaxima.lisp" into a normal maxima session I get
| > graphics chars out at the prompt.
|
| Do you mean control characters like ^D and ^C? That's intentional --
| imaxima.lisp inserts them to make the output from Maxima easier to
| parse.
Yes, they come out as graphics chars at the DOS command line, so that bit
sounds normal then.
Cheers
Mike Thomas
|
| _______________________________________________
| Maxima mailing list
| Maxima@www.math.utexas.edu
| http://www.math.utexas.edu/mailman/listinfo/maxima
|
|